Section 4. Product Program Mode; Modifying Product Settings - Henny Penny EEG-242 Technical Manual

4-1. MODIFYING PRODUCT
SETTINGS
Aug. 2014

SECTION 4. PRODUCT PROGRAM MODE

This mode allows you to program the following:
• Change Product Name
• Assign Button
• Change Times & Temp
• Change Cook ID
• Alarms
• Quality Timers
1. Press and hold
display, followed by "ENTER CODE".
2. Enter code 1, 2, 3 (first 3 product buttons). "PRODUCT"
and "PROGRAM" show in the displays, followed by
"SELECT PRODUCT' and "-P 1-" (ex: NUG).
Change Product Names
3. Use the ▲and ▼ buttons to scroll through the 40 products,
or press the desired product button.
4. Press ►button and "NAME" shows in the left display
and the product (ex: NUGGETS) shows in the right display.
5. Press √ button and the first letter in the name flashes.
Press a product button and the flashing letter changes to
the first letter under the product button that was pressed.
For example, if
to an "A".
Press the same button again and the flashing letter changes
to a "B". Press it again and the flashing letter changes to
a "C". Once the desired letter shows in the display, press
► button to continue to the next letter and repeat the
procedure.
Press and hold the right X button to exit Program Mode, or
press ► button to continue on to "COOK TIME".
Assign Button
6. Press ► button until "ASSIGN BTN" shows in the
display, along with the product (ex: NUGGETS). If this
product already has a product button assigned to it, that
LED will be lit. To assign other product buttons to that
product, press and hold the product button for 3 seconds
and that LED stays lit. To remove a product from a button,
press and hold the product button with a lit LED and the
LED goes out.
• Include in Filter Count (Global)
• Filter at X no. of loads (Mixed)
• Load Compensation
• Load Compensation Reference
• Full Heat
• PC Factor
button until "PROG" shows in the
is pressed, the flashing letter changes
17
Model EEG-241, 242, 243, 244