Parameter Assignment/Addressing; Parameter Assignment / Addressing Requirements; Factory Settings; Factory Settings Overview - Siemens SIMOTION P320-4 E Commissioning And Hardware Installation Manual

Parameter assignment/addressing

8.1

Parameter assignment / addressing requirements

The following actions should be completed before you start parameterizing or addressing:
● The SIMOTION P320‑4 and the other hardware are installed.
● The devices are connected.
● The required software is installed.
● The SIMOTION P320‑4 has been switched on.
The actual state should be saved after the parameterization.
8.2

Factory settings

8.2.1

Factory settings overview

Requirement
You have obtained information about the various communications models. Further information
can be found under HMI and SIMOTION SCOUT (Page 27).
You are familiar with the Windows Control Panel.
Resetting the factory settings
It is possible to reset SIMOTION P320‑4 to the factory settings (see section Resetting the
SIMOTION P to the initial state (Page 117)).
8.2.2

PC internal

SIMOTION P320‑4 delivery state
Local communication in the SIMOTION P320-4 between Windows programs such as HMI and
the SIMOTION P Runtime software is handled by the PC's internal communications
mechanisms.
Further information on how to check the settings in the Windows Control Panel can be found
in section Check PC internal settings (Page 80).
SIMOTION P320-4 E / P320-4 S
Commissioning and Hardware Installation Manual, 01/2015
8
73