Device Expansion And Parameter Assignment; Open The Device - Siemens SIMATIC IPC277E Operating Instructions Manual

Device expansion and parameter assignment

6.1

Open the device.

Requirement
● The device is disconnected from the power supply.
● All cables have been disconnected from the device.
● The device has been removed from the control cabinet.
● A T10 screwdriver
Procedure – Opening the 7" and 9" single-touch devices
Note
The drive is located on the underside of the device cover.
• Carefully open the device.
• You cannot set the device cover down because of the connecting cable of the drive.
• You first have to pull out the connection plug in order to completely remove the device
cover.
• Read the information in section "Replacing the drive (Page 82)".
SIMATIC IPC277E
Operating Instructions, 11/2019, A5E35783335-AE
Remove the marked screws
Open the device cover at the back
and set it and the drive vertically
against the device wall. Lay the
cover aside.
Notice: Connection plug and board
could be damaged.
Ensure that the device cover
•
does not fall down.
Remove the connection plug
•
from the drive.
6
73