Commissioning (software)
9.9 SIMOTION P overall reset
Figure 9-16
Further information
on the SIMOTION P State buttons can be found in the Function elements (Page 69) section.
9.9
SIMOTION P overall reset
9.9.1
SIMOTION P overall reset overview
Introduction
When an overall reset is performed, the RAM on the SIMOTION P320-4 will be cleared along
with any non-volatile data in the SRAM - with the exception of the communication configuration
(e.g. baud rates and network addresses). For further information see Non-volatile data and
SRAM handling (Page 123).
Below is a list of the data that is either capable or not capable of withstanding an overall reset.
Data on the external CFast card are retained.
110
Load project after Restart (Del. SRAM)
SIMOTION P320-4 E / P320-4 S
Commissioning and Hardware Installation Manual, 01/2015