Installing The Simotion P320-4 In The Control Cabinet; Notes On Installation; Standard Rail Mounting - Siemens SIMOTION P320-4 E Commissioning And Hardware Installation Manual

4.5

Installing the SIMOTION P320-4 in the control cabinet

4.5.1

Notes on installation

Requirement
Before you install the device, observe the following installation notes:
NOTICE
Observe the DIN/VDE requirements
Adhere to the relevant DIN/VDE requirements or the country-specific regulations when
installing in control cabinets.
NOTICE
Observe UL508
For use in the area of Industrial Control Equipment (UL508), remember that
SIMOTION P320-4 is classified as Open type.
Installation of the device in an enclosure according to UL508 is conditional for approval or
operation according to UL508.
Types of installation
The following SIMOTION P320‑4 installation types are permitted and described in the following
sections:
● Standard rail mounting (Page 39)
● Vertical mounting (Page 42)
4.5.2

Standard rail mounting

Mounting the SIMOTION P320-4 on a standard rail
Note
Use of Siemens 35 mm standard mounting rail is recommended.
Mounting the standard mounting rail clip
Before you can install the device on a standard mounting rail, you will need to attach the
standard mounting rail clip included in the scope of delivery.
SIMOTION P320-4 E / P320-4 S
Commissioning and Hardware Installation Manual, 01/2015
4.5 Installing the SIMOTION P320-4 in the control cabinet
Mounting
39