Temperature Alarm - Siemens SIMOTION P320-4 E Commissioning And Hardware Installation Manual

The LED combination flashes as long as the dialog is open and the Flashing function has not
been deactivated.
If the dialog box is closed without deactivating the Flashing function, the previous state of the
LED becomes active again.
Table 11-3 LED combinations
LED SF
DCP flashing x
x Not applicable
1 ON
2 Flashes with a frequency of 2 Hz.
Note
You can carry out a detailed diagnosis using a PG/PC and the Engineering System.
FAULT
A fault has occurred to which the user program cannot respond.
The following actions may be required to rectify the fault:
● Power OFF/ON
● Recommissioning
Table 11-4 LED combinations
LED SF
FAULT 2
(red)
2 Flashes with a frequency of 2 Hz.
11.2

Temperature alarm

For SIMOTION P320‑4, two different temperatures are monitored in the device as regard to
whether they reach their respective threshold value.
System variables
_cpudata.temperature
_cpudata.moduletemperature
SIMOTION P320-4 E / P320-4 S
Commissioning and Hardware Installation Manual, 01/2015
RUN STOPU
2 x
(green/yel‐
low)
RUN STOPU
2 2
(red) (red)
Alarm, error and system messages
STOP SF PN
x x
STOP SF PN
2 2
(red) (red)
11.2 Temperature alarm
SY/MT BUSF1
x x
SY/MT BUSF1
2 2
(red) (red)
BUSF2
x
BUSF2
2
(red)
129