Safety Instructions For Staff; Use Personal Safety Equipment; Safe Handling Of Wagner Powder Spray Devices - WAGNER Sprint 60 L XE Operating Manual

VERSION 05/2017
OPERATING MANUAL
4.2

SAFETY INSTRUCTIONS FOR STAFF

Always follow the information in this manual, particularly the safety instructions and
the warning instructions.
Always follow local regulations concerning occupational safety and accident prevention.
Under no circumstances should people with pacemakers be in the area where the
high-voltage fi eld between the spray gun and the work piece to be coated builds up!

4.2.1 USE PERSONAL SAFETY EQUIPMENT

Danger due to dust formation!
Serious or fatal injuries due to inhalation, swallowing or contact with the skin or eyes.
Observe the processing regulations laid down by the manufacturer of the powder
lacquer being used, when preparing or processing the powder.
Take note of the manufacturer's notifi cation and the relevant environmental
protection regulations when disposing of powder lacquers.
Take the specifi ed protective measures. In particular wear safety goggles, protective
clothing and gloves, as well as hand protection cream if necessary.
Use a mask or breathing apparatus if necessary.
For suffi cient health and environmental safety: Operate the device in a powder
coating booth or on a spraying wall with the ventilation (extraction) switched on.

4.2.2 SAFE HANDLING OF WAGNER POWDER SPRAY DEVICES

Danger due to dust formation!
Do not point spray guns at people.
Do not spray device parts using electrostatic equipment.
Before any work on the device, in the event of work interruptions and malfunctions:
– Switch off the energy/compressed air supply.
– Relieve pressure on powder spray gun and device.
– Secure the powder spray gun against actuation.
– Disconnect the control unit from the mains.
– In the event of functional faults: remedy the fault as described in the "Troubleshooting"
chapter.
Carry out the work steps as described in the "Pressure relief" chapter:
– if pressure relief is required,
– if the coating work is interrupted or stopped,
– before the device is cleaned on the outside, checked, or serviced,
– before the spray nozzle is installed or cleaned.
ORDER NUMBER DOC 2354920
SPRINT XE
15