Adjusting The Fluidization (Airfluid) - WAGNER Sprint 60 L XE Operating Manual

VERSION 05/2017
OPERATING MANUAL

7.2.2 ADJUSTING THE FLUIDIZATION (AIRFLUID)

1
ORDER NUMBER DOC 2354920
2
P_02640
Procedure:
1. Swivel the feed unit (1) to the right side.
2. Place an opened powder tank (25–30 kg; 55.11–
66.14 lbs) on the vibrator table.
3. Switch on the control unit.
4. Swivel the feed system (1) into the powder tank
and lower it down to the powder surface. Actuate
the trigger of the spray gun for a short time and
release it. The vibrator motor and the fl uid air
overrun for 10 s (factory setting). This setting
can be changed by the user if required (see EPG-
Sprint XE control unit operating manual).
5. Adjust the fl uid air at the throttle (2) to the
point that it makes the feed system sink into the
powder due to its own weight.
Note:
– The amount of fl uid air depends on the
characteristics of the powder.
– The powder should be moving in the suction
area of the feed unit (gently simmering).
– Avoid a dust build up in the powder tank.
SPRINT XE
40