VERSION 05/2017
OPERATING MANUAL
6.4
ASSEMBLING THE MANUAL SYSTEM
6.4.1 ASSEMBLING THE EQUIPMENT TROLLEY
The manual system's trolley is supplied unassembled for transport reasons. It must be
assembled as described below.
25Nm;
18.44lb ft
P_02643
6.4.2 ASSEMBLING THE CONTROL UNIT
3
1
2
P_02644
ORDER NUMBER DOC 2354920
3
2
1
4
Procedure:
1. Open transport packaging with care
and carefully take all single parts out of
packaging.
2. Place lower trolley section (1) on a clean,
level surface.
3. Place upper trolley section (2) on the two
guide sleeves on the lower trolley section
(1), press down gently until stop is reached
and use nuts and bolts (see detail) to screw
to lower trolley section (tightening torque
25 Nm; 18.44 lb/ft).
4. Mount the gun holder (3) (see separate
assembly manual).
Procedure:
1. Carefully take control unit (1) out of
packaging and use the supplied screws (2)
to screw into the holes drilled in the angle
bracket (3).
Mount the control unit such that it is fl ush
with the cover at the front.
SPRINT XE
30