Tank Version - WAGNER Sprint 60 L XE Operating Manual

VERSION 05/2017
OPERATING MANUAL
8.3.2 60 L TANK VERSION
50
60
40
3
m /h
Ø
30
Tri
3.0
5.5
12
1.5
4.5
11
20
0.5
3.5
10
9
0.3
2.5
8
10
0.1
2.0
100 %
0 %
P_01785
4
6
7
8
8
P_01141
ORDER NUMBER DOC 2354920
70
80
90
17
SP RI N T X
EPG
5
1
3
2
P_01140
9
10
Procedure:
1. Release the trigger on the spray gun.
The high voltage and the powder feed are
deactivated.
2. Remove powder injector (1) from holder (2).
3. Hold the gun in the spray booth and start the
fl ush function by pressing the "Flush" button (17).
The injector and hoses are fl ushed.
4. Switch off control unit.
5. Release the union nut on powder feed hose
(3) and disconnect powder feed hose (3) from
injector (1).
6. Disconnect the red feed air hose (4) from injector
(1).
7. Disconnect the blue dosing air hose (5) from the
injector (1).
8. Check powder injector for wear and replace
worn parts if necessary.
The wearing and spare parts can be found in the
powder injector's operating manual.
9. Loosen the exhaust air hose (6) from the
connection (7) of the powder tank (8).
10. Pull the black fl uid air hose (9) off the powder
tank (8).
11. Loosen the grounding cable (10) from the
powder tank (8).
12. Lift the powder tank off from the equipment
trolley for cleaning.
13. Open the lid of the powder tank to empty the
powder tank and thoroughly blow out the
powder tank.
14. Completely remove all residual powder from the
suction system.
15. Pay special attention when cleaning the fl uid
base, check it for blockage or damage and
replace it if necessary.
The wearing and spare parts are in the "Spare
Parts" chapter of this operating manual.
SPRINT XE
53