Cleaning And Flushing; Maintenance And Repair - WAGNER Sprint 60 L XE Operating Manual

VERSION 05/2017
OPERATING MANUAL

4.2.5 CLEANING AND FLUSHING

Hazard due to cleaning and fl ushing
Explosion hazard and damage to the device.
Before starting cleaning or any other manual work, the high voltage in the spray area
must be shut down and locked to prevent it from being switched back on.
Lock the compressed air supply and decompress the device.
Secure the device against being switched back on without authorization.
Use only electrically conducting and grounded tanks for cleaning fl uids.
Preference should be given to non-fl ammable cleaning fl uids.
If fl ammable cleaning fl uids are used, all parts carrying high voltage must be
discharged to a discharge energy of less than 0.24 mJ, once the high voltage has
been switched off , before they can be reached.
Most fl ammable solvents have an ignition energy of around 0.24 mJ or 60 nC.
The cleaning agent's fl ash point must be at least 15 K above the ambient temperature.
Only mobile industrial vacuum cleaners of design 1 (see EN 60335-2) may be used for
getting rid of dust build-ups.
Take measures for workplace safety (see chapter 4.1.2).

4.2.6 MAINTENANCE AND REPAIR

Hazard due to improper maintenance and repair!
Danger to life and equipment damage.
Only a WAGNER service center or a suitably trained person may carry out repairs and
replace parts.
Repair or replacement of devices or parts of devices are only allowed to be performed
outside the hazard area by qualifi ed personnel.
Do not change or modify the device; if change is necessary, contact WAGNER.
Only repair and replace parts that are listed in the
that are assigned to the unit.
Do not use any defective components.
Exclusively use accessories listed in Chapter
Before all work on the device and in the event of work interruptions:
- Switch off the energy and compressed air supply.
- Relieve pressure on powder spray gun and device.
- Secure the powder spray gun against actuation.
Observe the operating and service manual for all work.
ORDER NUMBER DOC 2354920
12
12 and that are assigned to the unit.
"Spare parts" chapter and
SPRINT XE
13
17