BCDVideo BCD-RGD-804P-MT User Manual page 42

LLDP Parameter configuration: Interface items introduction:
Interface items Configuration
Tx Interval 5-32768 second
Tx Hold
2-10 times
Tx Delay 1-8192 second
TxReinit 1-10 second
LLDP Parameter configuration: Interface items introduction:
Interface items Configuration
Port 1-n
Mode Disabled
Enabled
Rx Only
Tx Only
Port Descr Tick/Not tick
Sys Name
Tick/Not tick
Sys Descr Tick/Not tick
Sys Capa Tick/Not tick
MgmtAddr Tick/Not tick
42
Introduction
The time interval of switch to send LLDP frames to the
neighbor
Multiple frame interval for configuring LLDP frame effective
time, the effective time = Tx Hold x Tx Interval
After LLDP configuration change, time to re-transmission
and the last time interval between frames LLDP, <= 1/4 Tx
Interval
Time interval between LLDP stop frame and a new start
frame
Introduction
Switch port number
The port is configured to not send or accept LLDP frame
Port is configured as both sending and receiving LLDP
frame
Port is configured to only receive not send LLDP frame
Port is configured to only transmit LLDP frames
When ticked, the port description information transmit
contained TLV in LLDP frame, and did not tick the TLV infor-
mation is not included in LLDP frame, transmission
When ticked, the "System Name" will be included in LLDP
frame transmission, and did not tick the "System Name" is
not included in LLDP frame, transmission
When ticked, the "System Description" will be included
in LLDP frame transmission, and did not tick the "System
Description" is not included in LLDP frame, transmission
When ticked, the "System Properties" will be included in
LLDP frame transmission, and did not tick the "System
Properties" does not contain the transmission in LLDP
frame
When ticked, "Managing Address" will be included in LLDP
frame transmission, and did not tick the "Manage Address-
es" are not included in LLDP frame, transmission
BCD-RGD-804P-MT
Factory setting
30
4
2
2
Factory setting
1-n
Disabled
Tick
Tick
Tick
Tick
Tick
www.bcdvideo.com