BCDVideo BCD-RGD-804P-MT User Manual page 15

D. Access management configuration
Enter [Switch] →[Access Management] navigation column,Page is used to regulate the access management. Select Open
access control management mode, click on the "Add New Entry" button, typing "Start IP Address (beginning IP address)",
"End IP Address (End IP address)", select "HTTP / HTTPS", "SNMP", at least select a permissible service.
Click [Save] button to complete the access management configuration. Check delete selection on the corresponding
clause, click the check box to complete the deletion.
Interface items Configuration
Mode Disable/Enable
VLAN ID 1-4095
Start IP Address IP Address
End IP Address IP address
HTTP/HTTPS Select / not selected
SNMP Select / not selected
Add New Entry: Click to add a new interface.
Delete:
5.2.2.4 SNMP Configuration
A. SNMP system configuration
Enter 【SNMP configuration【→【System【navigation
column,If your network is configured with the SNMP server,
the switch can configure SNMP parameters, connect the
SNMP server. When selected SNMP v3 version needs to be
configured for specific functional parameters about SNMP
v3 security certification, groups, views and so on.
BCD-RGD-804P-MT
Introduction
off/one access control management
IP segment belongs VLAN
Access the start IP address
Access the end IP address
Selected, The IP address can accessed through HTTP/
HTTPS
Selected, The IP address can accessed through SNMP
Factory setting
Disable
1
0.0.0.0
0.0.0.0
Not selected
Not selected
15