BCDVideo BCD-RGD-804P-MT User Manual page 10

D. Log Server Configuration
Enter [System] → [Log] navigation column, log configuration page, you can configure a remote logging server information,
the device logs information [Save] to a remote server, providing backup viewing. Select the server mode, set the server
address, select the log level, click [Save] button to complete the system logging configuration.
Interface items introduction:
Interface items
Server Mode
When the mode operation is
enabled, the syslog message will
send out to syslog server.
Server Address
5.2.2.2 Ports
Enter the [Ports] navigation column, you can view the connection status of each port, including: link connection, speed,
flow control and maximum frame size and other information, No 1-6 for the front panel port 100M / 1000M RJ45 ports, No
7-8 port for the data connection port, No 9-10 port Gigabit optical interfaces. Link status indication red indicates that the
link down state; green indicates that the link up state.
Port rate mode:
Ports can be selected as "Auto", "Disabled", "10mbps HDX", "10mbps FDX", "100Mpbs HDX", "100Mpbs FDX", "1Gbps FDX";
This option may be set directly: Auto can automatic identification access type.
Flow Control: enable the port flow control, implement port flow control
The maximum frame size that can be configured port maximum transmission unit, the default is 9600. Select the relevant
parameters, click [Save] button to complete the port configuration. Also Click [Save] button to save changes. Click [Reset]to
cancel any changes made locally and return to previously saved values.
10
Configuration Introduction
Disable/Enable Indicates the server mode operation.
Disable Switch name, is used to specify switch function
(The first must be a letter, the last one cannot be
a special sign)
Log configuration Configure log server IP address
IP address
BCD-RGD-804P-MT
Factory setting
No
No
No
www.bcdvideo.com