BCDVideo BCD-RGD-804P-MT User Manual page 34

Interface items Configuration
Port
1-n (Number of physical
ports)
LACP Enabled Select/not select
Key Auto/Specific(1-65535)
Role Active/Passive
Timeout Fast/slow
Prio 1-65535
5.2.2.8 Loop Protection
Enter [Loop Protection] navigation column. This page allows the user to inspect the current Loop Protection
configurations and set relevant parameters, click [Save] button to save changes.
34
BCD-RGD-804P-MT
Introduction
The switch port number.
Controls whether LACP is enabled on this switch port.
LACP will form an aggregation when 2 or more ports are
connected to the same partner.
The Key value incurred by the port, range 1-65535 . The
Auto setting will set the key as appropriate by the physical
link speed, 10Mb = 1, 100Mb = 2, 1Gb = 3. Using the Specific
setting, a user-defined value can be entered. Ports with the
same Key value can participate in the same aggregation
group, while ports with different keys cannot.
The Role shows the LACP activity status. The Active will
transmit LACP packets each second, while Passive will wait
for a LACP packet from a partner (speak if spoken to).
The Timeout controls the period between BPDU transmis-
sions. Fast will transmit LACP packets each second, while
Slow will wait for 30 seconds before sending a LACP packet.
The Prio controls the priority of the port. If the LACP part-
ner wants to form a larger group than is supported by this
device then this parameter will control which ports will be
active and which ports will be in a backup role. Lower num-
ber means greater priority.
Factory setting
1-n
not select
Auto
Not select
Fast
32768
www.bcdvideo.com