BCDVideo BCD-RGD-804P-MT User Manual page 18

Industrial gigabit ethernet switch with poe+
Hide thumbs Also See for BCD-RGD-804P-MT:
Table of Contents

Advertisement

Interface items introduction:
Interface items
Configuration
Trap Config name
0~255 Byte
Trap Mode
Disable/Enable
Trap Version
SNMP V1/SNMP
V2C/SNMP V3
Trap Community
Public/private
String
Trap Destination
IP address
Address
Trap Destination
Port address
Port
Trap Inform Mode
Disable/Enable
Trap Inform Tim-
0-2147 second
eout
Trap Inform Retry
0-255 time
Times
Trap Probe Security
Disable/Enable
Engine ID
Trap Security En-
10-64 hexadecimal
gine ID
digits, not allowed
all 0, all 1
Trap Security Name
Trap Event
C. SNMP Community Configuration
Enter [SNMP Configuration] → [Community] navigation column, Configure SNMPv3 community table on this page.
This function is used for only one IP address to restrict the information requested or received.
18
BCD-RGD-804P-MT
Introduction
Indicates which trap Configuration's name for configuring. The
allowed string length is 1 to 255, and the allowed content is
ASCII characters from 33 to 126.
Indicates the SNMP mode operation.
Indicates the SNMP supported version.
Indicates the community access string when sending SNMP trap
packet. The allowed string length is 0 to 255, and the allowed
content is ASCII characters from 33 to 126.
Indicates the SNMP trap destination address. It allow a valid IP
address in dotted decimal notation ('x.y.z.w').
Indicates the SNMP trap destination port. SNMP Agent will send
SNMP message via this port, the port range is 1~65535.
Indicates the SNMP trap inform mode operation.
Indicates the SNMP trap inform timeout.
The allowed range is 0 to 2147.
Indicates the SNMP trap inform retry times.
The allowed range is 0 to 255.
Indicates the SNMP trap probe security engine ID mode of oper-
ation.
Indicates the SNMP trap security engine ID.
Indicates the SNMP trap security name.
SNMPv3 traps and informs using USM for authentication and
privacy. A unique security
name is needed when traps and informs are enabled.
Configure SNMP trap on this page.
Factory
setting
No
Disable
SNMP V2C
Public
No
162
Disable
3
5
ProbeFail
None
www.bcdvideo.com

Advertisement

Table of Contents
loading

Related Products for BCDVideo BCD-RGD-804P-MT

Table of Contents