Table of Contents
Advertisement
Interface items
Mode
Version
Read Community
The allowed string length is 0 to
255, and the allowed content is
the ASCII characters from 33 to
126.
Write Community
Engine ID
B. SNMP Trap Configuration
Enter [SNMP configuration]→[Trap], This page is used to configure the SNMP Trap function. The feature set SNMP Trap Active
upload function followed protocol version, community, destination IP address, port number, and whether to use the Trap
Inform, if you use Trap Inform, the corresponding timeout, retransmission parameters, and safety Engine ID. While providing
local support for those events triggered Trap, such as: switch hot start, cold start, port status, authentication fails.
16
Configuration
Introduction
Disable/Enable Indicates the SNMP mode operation.
SNMP V1/
Indicates the SNMP supported version.
SNMP V2C/
SNMP V3
0-255 string
Indicates the community read access string to per-
mit access to SNMP agent.
Public
0-255 string
Indicates the community write access string to per-
mit access to SNMP agent.
16Decimal
Indicates the SNMPv3 engine ID. The string must
contain an even number(in hexadecimal format)
with number of digits between 10 and 64, but
all-zeros and all-'F's are not allowed. Change of the
Engine ID will clear all original local users.
BCD-RGD-804P-MT
Factory setting
Enable
SNMP V2C
private
www.bcdvideo.com
Advertisement
Table of Contents
