BCDVideo BCD-RGD-804P-MT User Manual page 38

Interface items introduction:
Interface items Configuration
Port 1- n
STP Enabled Select/not Select
Path Cost
Auto/ Specific:1-
200000000
Priority
0/16/32....240
AdminEdge Non-Edge/Edge
AdminEdge
Select/not Select
Restricted Role
Select/not Select
Restricted TCN Select/not Select
BPDU Guard Select/not Select
Point-to-Point Auto
Forced True
Forced False
5.2.2.10 IPMC Configuration
A. IGMP Snooping basic configuration
Enter [IGMP Snooping configuration] → [Basic] navigation column, Common configuration can enable the multicast listener
function to achieve the IGMP packet detection, and for the host and corresponding port and establish the corresponding
multicast group address mappings. Broadcast unknown multicast function is configured for unregistered multicast packets
discarded or broadcast operations.
Port can be configured router port, does not age. When receiving an IGMP query is not configured for the port on the router
port, the switch that the port is connected with IGMP router (direct or indirect), on the port recorded as dynamic routing port.
When the switch receives IGMP reports will be forwarded to the router port.
Tick Snooping enabled, the port 1-2 routing port, fast leave options, click [Save] button to complete the IGMP Snooping,
Port configurations.
38
BCD-RGD-804P-MT
Introduction
Switch port number
off/ on port STP Enabled
Path cost, when selecting Auto the system will be based
on the connection speed to use STP recommended
values. When you select Specific, enter a value between
1-200000000 only as a path overhead.
Port Priority
Set the port connected device is STP bridge device or a
non-bridge device, if non-bridge device, configured as
Edge, will speed forwarding rate.
When selected enter the auto detect whether the port is
an edge port, according to the results of the monitoring
configuration itself edge port.
When Selected, the device serves as limit state, not select
to the root port
When Selected, TCP packet forwarding equipment limita-
tions, namely, it does not forward the received TCN (Topol-
ogy Change Notification) message to other ports
When Selected, the port does not receive a valid BPDU
Device Automatic detection link is connected to this port is
point to point
Set this port to connect the device to force the link to point
Set this port to connect the device to force non-point link
Factory setting
1-n
Select
Auto
128
Non-Edge
Select
not Select
not Select
Auto
www.bcdvideo.com