Table of Contents
Advertisement
BCD-RGD-804P-MT
B. STP port configuration
Enter [Spanning Tree configuration] → [CIST Ports] navigation column, All ports by default are run Spanning Tree Protocol to
prevent loops. Port path cost default is Auto, users can manually specify, among 1-200000000, the smaller the value the more
priority path. Port priority, use in the spanning tree calculation process for 0/16/32/48 / ... / 224/240, the default is 128. Edge
port is use for switch connected to computer or connect network device without the spanning tree function. At this port
directly into the forwarding state, will not participate in the logical topology calculations.
37
Advertisement
Table of Contents
