Table of Contents
Advertisement
TECHNICAL MANUAL LEON CUP RACER
Process:
1.
After the grid formation lap, stop completely the car on the grid line pushing the brake pedal.
Gear lever has to be in "S" or "TS" mode. If this mode was already in during formation lap, will
2.
not be necessary move the gear lever.
3.
Push foot throttle flat out. Engine will limit at ±4200 rpm.
4.
Release the brake pedal and car will be launched. Driver has to control the wheel spin with the
gas pedal.
Summarizing: Arriving from the formation lap driving in "S" or "TS stops the car on the grid line
pressing the brake pedal. Push the foot throttle flat out (4200rpm) and release the brake when
you decide.
(max time flat out 6 sec)
Control the wheel spin and enjoy.
Notes:
Starting in "S" is necessary to release a little bit the gas pedal from the full gas to disable the
launch system. After this, using the "S" mode, up shift is automatic.
Is possible to use the Launch Control System controlling the rpm. Advisable no bellow of 3500
rpm.
The system need brake press >10 bar. Push the brake pedal clearly.
With start lights in red: If you release just a little bit the brake pedal in any moment of the system
process will understand that launch is done and the clutch will load irreversibly.
MANUAL LAUCH SYSTEM
It's possible to carry out a manu
al launching whit the same success.
Process:
1.
After the grid formation lap, stops completely the car on the grid line.
2.
Push the brake pedal (Brake press >25 bar)
Gear lever has to be in "S" or "TS" mode. If this mode was already in, it's not necessary move
3.
the gear lever.
4.
Release the brake pedal while you press down the gas pedal.
Notes:
It's also possible to while you are braking put the engine in charge accelerating a little bit.
care the time you apply the engine charge because the clutch takes temperature very fast and
after a certain limit the clutch launch is coming slow.
seconds.
2.5
Speed limiter system
The speed limiter system allows limiting the car speed. This system is recommended for the pit lane area.
Speed limiter limitation is 60Km/h (tolerance - 2 km/h GPS speed)
Process:
1.
Brake to reduce the car speed around 60 km/h or little less.
2.
Release the brake and press the steering wheel red button as long as you want it acts.
3.
Push the gas pedal fully. Car speed has to be limited.
Recommendation not more than 3
Take
14 de 48
Advertisement
Table of Contents
