Table of Contents
Advertisement
Service
▀
Don´t "tap" the lamba against something in order to get it clean.
Use a brush.
Lambda
The Lambda needs to be cleaned once a year. Unscrew it
from the flue tube. Brush it clean and make sure that the
holes on the top are clean.
Outer tube
After a period of heating up, there will be dust and ash
from the burner´s inner and outer tube. It must be removed
to avoid deterioration in combustion and function. We
recommend that the cleaning is done after about 3 tonnes
of pellets consumption. After the cover is removed, start by
loosening the four wing nuts (1) wich are holding the burner
in place and then unload according to description. Then pull
out the inner combustion tube (2) and clean from ash and
soot. It is important that the holes are not clogged with ash,
as these are essential to good combustion.
Then clean the outer tube (3) from the ash and pellet
residues.
Reassemble in reverse order.
Changing and/or servicing the flame sensor
Remove the contact to the flame sensor by pulling straight
back (1). The outer nut of the flame sensor is loosened
completely (2). Pull the flame sensor, with nut and clamp
bushing, out of the container. If you are going to replace the
flame sensor, move the nut and clamp bushing to the new
sensor. The clamp bushing is to be pushed fully back against
the shrink tubing. Mount the flame sensor in the container.
Screw the nut by hand so that the sensor is tight, but not
overly. Mount the flame sensors contact (1).
Effecta AB - Västra Rågdalsvägen 21 - 434 99 Kungsbacka - 0300 - 22320 - info@effecta.se
45
Advertisement
Table of Contents
