Table of Contents
Advertisement
Electrical connection
▀
NOTE! The boiler must be filled with water before the wiring begins.
For wiring to the motherboard you need to use a standard
screwdriver with a tip width of 3mm and a length of about
12cm. You can open the spring load of the motherboard in
both the tracks that are on every cable entry.
When it's time to do the electrical connection you need to
remove the front casing which is in front of the motherboard.
On the backside of the boiler there are eight (1) conduits
that end in the front of the boiler. These are used to connect
the sensors and electrical cables. Don't put the low and
high voltage in the same hose, it can effect the showing of
temperature. To remove the front casing, grab the two handles
and pull it straight out, hard. Then connect the input voltage to
the card's ports.
Power guard
If the electricity comsumption is high in the pro-
perty while the electrical heater is
operating there is a risk that the pro-
pertys main fuses will blow. The Effecta
Komplett III is equipped with a power
guard which prevents electrical over-
load by redistributing the power supply
between the phases.
Connection of current sensors
To measure the power you must install
one current sensor to each incoming
phase in the house. This must be done
directly in the electrical control. Con-
nect the sensors to a cable with the
area of 0,5mm2 to the circuit board. In
the "electrical heater" menu you set
the max power that's allowed on the
fuses in your house.
Effecta AB - Västra Rågdalsvägen 21 - 434 99 Kungsbacka - 0300 - 22320 - info@effecta.se
VARNING LIVSFARLIG SPÄNNING
WARNING DANGEROUS VOLTAGE
ACHTUNG GEFÄHRLICHE SPANNUNG
AVERTISSEMENT TENSION DANGEREUSE
VARNING LIVSFARLIG SPÄNNING
WARNING DANGEROUS VOLTAGE
ACHTUNG GEFÄHRLICHE SPANNUNG
AVERTISSEMENT TENSION DANGEREUSE
VARNING LIVSFARLIG SPÄNNING
WARNING DANGEROUS VOLTAGE
ACHTUNG GEFÄHRLICHE SPANNUNG
AVERTISSEMENT TENSION DANGEREUSE
23
Advertisement
Table of Contents
