Effecta KOMPLETT III Installing, Maintenance, Service, Assembly page 39

20-25-35 kw

Hide thumbs Also See for KOMPLETT III:

Table of Contents

Mounting and adjusting of the draft stabiliser

▀

A draft stabiliser makes sure that a constant and stable draft is achieved. Also condensation

in the chimney is avoided. To confirm the desired effect is achieved it should be verified by the

installer or property owner. Tigex draft stabiliser has developed a design which enables mounting of

the flue tube in all directions, vertical, angled as well as horizontal. Tigex is mounted on a adaption

plate, which can be located where it is best suited on the flue tube.

Adjusting the balancing shaft

To adjust this shaft, loosen the two screws a bit and turn the shaft so that it is horisontally when

the hatch is closed. Then fasten the screws.

Adjusting the draft

CLOSED

LOCK

OPEN

By moving the counterweight along the balance shaft, the draft needed to open the hatch is

adjusted. About 1Pa per 2mm.(fig.2) The hatch is preset at about 10Pa. A professional should

measure the draft and make the adjustments.

COUNTER WEIGHT

Functions

CLAMP

Tigex draft stabiliser opens the hatch just as much as is needed depending on the current draft.

BALANCE SHAFT

SCREWS FOR LOCKING

The draft varies a lot depending on the chimney, weather and also if the burner is running or

not. This means that the hatch can be open a lot, a little or closed, depending on the situation

and the need for ventilation in the chimney . The need for ventilation in the chimney varies greatly

between different sites, so the required pressure and ventilation needs must be determined on a

case to case basis.