Table of Contents
Advertisement
Installation of suction nozzles
▀
Regardless of the number of nozzles installed there will always be a certain amount of
pellets left in the bottom of the storage.
The nozzles are designed so that they can be mounted on the bottom of a flat storage or in a
storage with a sloped wall. It is important that the slope of the wall is 45º so that the mounting
plate comes in at the right angle. Make sure to seal behind the mounting plate so no dust can
leak out. When the nozzle is placed on the bottom of the storage it is important that it is bolted
firmly due to the pressure it has to take when the storage is filled with pellets.
▀
Mounting of hoses
When mounting the hoses make sure that all connections are tight. The hoses must
also be grounded to avoid static electricity.
22
Effecta AB - Västra Rågdalsvägen 21 - 434 99 Kungsbacka - 0300 - 22320 - info@effecta.se
600
1200
1200
600
Max 12m
Max 15m
Flat bottom
When placing the nozzles on the bottom you
need to decide how many to place. We re-
commend a distance of 600mm from wall and
1200mm between the nozzles. It is possible to
place them further apart but it effects the ability
to empty the storage completely.
Sloped wall
In a storage with sloped walls we recommed a
distance between the nozzles of 1200mm and
600mm from a vertical wall. The wall the nozzle
is to be mounted on must have a slope of 45º.
The suction motor on the boilers storage
has limitations in which underpressure it can
produce. Therefore, it is important that the
hoses between the switch and the boiler are
not too long. We can guarantee the function
according to the distances on the sketch, if you
want a longer distance there is a risk for reduced
feeding and disruptions to the boiler. It is
paramount that the connections against nozzles
and switches are tight. If there are leaks, the
suction capacity deteriorates significantly.
Advertisement
Table of Contents
