Service And Cleaning - Effecta Komplett III Owner's Manual

Service and cleaning

▀
Cut the power to the boiler before starting the service. We recommend a good service/
cleaning of the burner and boiler 2-3 times a year. Do as follows for best result and minimizing
the chances for downtime.
Sweeping interval
1. Ash compartment, if necessary, or at about 3 tons of
pellets consumption.
2. Burner tubes after 3 tons of pellets consumption.
3. Convection part 3 tons of pellets consumption.
3. Without automatic cleaning every other week in winter.
4. Soot box if necessary.
5. Smoke connection and fan after 3 tons of pellets consumption.
Make sure to clean the area between soot box and smoke
connection
6. Flue tube after 3 tons of pellets consumption.
7. The burner's outer tube 6 tons of pellets consumption.
8. Flame sensor after 6 tons of pellets consumption (page 30)
Approx. life span for ware parts
1. Igniter
2. Flame sensor
3. Inner tube
4. Burner fan
5. Exhaust fan
6. Sealings
Cleaning the ash compartment
Cleaning the ash compartment is done through the ash door on the front. The easiest way is to
use some type of ash cleaner. If you do not have access to a an ash cleaner, remove the ash
with a scrape and keep it in a fireproof bin. Remember that ashes can contain hot particles for a
long time and may not be stored near flammable materials.
Cleaning the burner
Remove the ash contained in the burner tube, this is done either through the ash compartment
with the supplied scraper or by taking the burner tubes apart outside the boiler, which
sometimes can be the easiest way.
Cleaning of convection
Cleaning of the tubes is done with the
It is important for the efficiency that these are cleaned thoroughly at the service. Clean the area
between the soot box and smoke connection.
Cleaning of ash and flue
Soot box, which is placed above the tubes must be emptied of ash, if the soot box is full, the
flue gas has no place to escape out through the chimney and you will receive a disruption. Also
clean the flue tube that goes to the chimney, when it is not certain that the chimney sweep do it.
The burner's outer / inner combustion tube
The space between the outer - inner tube must be cleaned out of dust and particles after about
6 tons of pellets consumption (page 32)
Effecta AB Västra Rågdalsvägen 21 434 99 Kungsbacka Sweden +46-300 - 22320 info@effecta.se
3-5 years
5-10 years
3-5 years
5-10 years
5-10 years
5-10 years
included brush, lifting the turbulators acc. (page 12).
29