Table of Contents
Advertisement
▀
Service
Internal feeder
Remove cover plates. Unscrew the 4 bolts which hold the
motor in place (1). Pull the motor and spiral down diagonally
(2). Use a vacuum cleaner to remove the dust. If there is
packed dust, the spiral and motor needs to be separated.
Unscrew the bolt located on the shaft (3).
Safety ball valve and angle
If service or cleaning need to be done in the fallout bend
that is located before the safety ball valve, loosen the 2
nuts (1) which holds the bend in place. Then loosen the
hose clamp which holds the plastic hose to the ball valve
(2). The bend is now free and can be cleaned. Make sure
that there is no packed dust at the top of the feed beam.
When reassembling, ensure the hose clamp is tight.
Internal storage
To clean the internal storage do as follows:
Remove the insulated cover plate (1).
Unscrew the 10 bolts which holds the lid to the storage (2).
Clean the grate under the suction motor (3), if the grid gets
clogged the suction deteriorates. The proximity sensor is
wiped carefully so no dust is sitting on the sensor (4).
Clean the storage from dust etc. Be extra careful at the
inlet to the feeder (5).
When reassembling make sure all sealing and bolts
are tight. If the storage is not tight there will be no
underpressure and no pellets will feed through.
46
Effecta AB - Västra Rågdalsvägen 21 - 434 99 Kungsbacka - 0300 - 22320 - info@effecta.se
Advertisement
Table of Contents
