Adjusting Door To Ash Compartment - Effecta KOMPLETT III Installing, Maintenance, Service, Assembly

Adjusting door to ash compartment

▀
There are several ways to adjust the door. In the picture below you see the hinge to the door to
the ash compartment. After some time of use some adjustments may have to be done in order
to ensure the door seals correctly.
1. Depth adjustment
If the seal is not tight on the hinge side, loosen the 2
bolts that holds the hinge to the frame. Loosen the
bolts about two turns then adjust the door inward to
tighten the door and reverse to loosen the pressure on
the sealing.
2. Vertical adjustment
In order to centre the sealing over the frame loosen the
two bolts (2) on the outside of the door. Loosen the
bolts abouts two turns and adjust the door.
3. Lateral adjustment
To centre the sealing sideways loosen the two bolts
(2) and adjust with the the two bolts (3). Make sure to
tighten all bolts when adjustment is completed.
Adjustment of the door locking
If the seal is not tight on the handle side, loosen the
two bolts (1) which holds the lock in place. Loosen
about two turns and push the lock inwards to tighten
and reverse to loosen. If the door handle is not in a
horizontal position when the door is closed, you can
adjust the bolt (2) up or down to change the position.
Effecta AB - Västra Rågdalsvägen 21 - 434 99 Kungsbacka - 0300 - 22320 - info@effecta.se
47