Table of Contents
Advertisement
EDITION 05/2015
OPERATING MANUAL
5.6
SPRAYING PROCEDURE
5.6.1
SPRAYING PROCEDURE FOR AIRCOAT ROUND SPRAY
In the AirCoat process, the spray product is atomized under a pressure of 3-15 MPa; 30-150 bar; 435-2,176 psi.
With the help of an air pressure of 0-0.25 MPa; 0-2.5 bar; 0-36 psi, a soft, spray jet is produced. The spray jet
diameter can be adjusted by turning the nozzle nut.
Advantages
- Large application volume
- Low fogging tendency
- Good fi nish
- High viscosity products can easily be applied
- High endurance of the nozzles
- Jet width adjustment
5.6.2
SPRAYING PROCEDURE FOR AIRCOAT FAN SPRAY
In the AirCoat process, the spray product is atomized under a pressure of 3-15 MPa;
30-150 bar; 435-2,176 psi. With the help of the AirCoat air, with a pressure of 0-0.25 MPa;
0-2.5 bar; 0-36 psi, a soft, fl at spray jet is produced which largely eliminates the problem of
overlapping in the peripheral zones. With shaping air, there is the possibility of reducing
the width of the spray jet.
Advantages
- Large application volume
- Low fogging tendency
- Good fi nish
- High viscosity products can easily be applied
- High endurance of the nozzles
- Jet width adjustment
ORDER NUMBER DOC2319150
AirCoat air
Spray product
AirCoat air
Variable spray jet
width
Nozzle nut
Multi-channel swirl
nozzle
Shaping air
Atomizing air
Spray jet
Air cap
B_00020
25
Advertisement
Table of Contents
