Disposal Of Packaging Material; Storage - RMG PGC 9300 Operating Manual

Measuring element

Hide thumbs Also See for PGC 9300:

Table of Contents

1.2.9

Disposal of packaging material

Dispose of the material in an environmentally friendly manner in accordance with

national standards and directives.

1.2.10

Avoid extended periods of storage. The PGC 9300 is a high-precision measuring

device that should not be stored for an extended time. A new factory calibration

may be necessary after an extended period of storage (longer than 4 weeks). In-

spect the gas chromatograph PGC 9300 for damage and correct function after

storage. Contact the RMG service department to arrange for inspection of the de-

vice after a storage period of longer than one year. For this purpose, send the de-

vice to RMG.

However, if storage is necessary, the following must be observed:

• The PGC 9300 must be positioned upright after it has been unloaded

• The PGC 9300 must be secured against movement and tipping over

• Storage in an air-conditioned and dry environment is required due to the

sensitivity to moisture

• All supply and discharge lines for gas must be sealed during storage (condi-

tion as delivered). If applicable, seal the lines with sealing plugs or dummy

plugs.

• Installation must be carried out by qualified personnel only.

• If storage times of longer than 4 weeks are necessary, a permanent carrier

gas flush must be provided.

An alternative storage is described in chapter 0

1 About this manual

Manual PGC 9300 EN07 June, 18th 2018

Table of Contents