How To Use Power Management Software - Sanyo Denki SANUPS E11A102U-J Instruction Manual

Power Management Software
§ 1 6 .
§ 1 6 .
H
H
What is Power Management Software "SANUPS SOFTWARE STANDALONE" (supplied CD-ROM)?
This software is used for power supply control or management from the computer by communicating the
UPS to a computer (personal computer or workstation).
Install power management software on your computer.
For more information, refer to the
software.
The following is the minimum system configuration required for the setup and operation of the
SANUPS SOFTWARE STANDALONE.
Computer: AT compatible
CPU: PentiumⅢ
Memory: Minimum of 32 MB (64 MB or more recommended)
Available disk space: Minimum of 95MB
Display: Minimum 640 x 480 pixel resolution
Supported OS: Windows
Service Pack 6 or above.
(*1)
① Check that "Interface" in the user setting is set to "Workstation". The factory default setting is
"Workstation". See §3.5 "Setting PC Interface" in the
② Connect the "PC/IF" connector of UPS to the computer using the supplied Network cable.
③ Check that network cable connection is not loose.
Note
CARD I/F connector and PC I/F connecter can not be used simultaneously.
④ Insert the SANUPS SOFTWARE STANDALONE CD-ROM into the CD-ROM drive to install this
program.
The installation program starts automatically. Proceed as instructed on the screen.
⑤ After completing the software installation, reboot the computer.
⑥ Launch the SANUPS SOFTWARE STANDALONE from the Windows Start menu to set up.
For more usage information, refer to the
management software.
47
o w t o U s e P
o w t o U s e P
Install Guide and User Guide
500MHz (or greater)
®
NT 4.0 ,Windows
® (*1)
Windows Vista(x86, x64), Windows
®
Windows 8(x86,x64),Windows
®
Standard Edition or Enterprise Edition.
(*2)
Connect PC/WS side of the cable to
the "RS-232C" connector of the computer.
This completes preparation to use SANUPS SOFTWARE STANDALONE.
o w e r M a n a g
o w e r M a n a g
in the CD-ROM of the power management
2000, Windows XP(x86, x64) , Windows
® ®
Server 2008(x86, x64)
®
Server 2012(x64)
®
User Settings Guide
Connect UPS side of the cable
to the "PC I/F" connector of the UPS.
If the installation program does not start
automatically, double-click Setup.exe on the
CD-ROM to start installation manually.
Install Guide and User Guide
e m e n t S o f t w
e m e n t S o f t w
Server 2003(x86, x64)
®
, Windows 7(x86, x64),
(*3) ®
Standard or Enterprise
(*3)
for how to set.
in the CD-ROM of the power
a r e
a r e
,
(*2)
T i p