Table of Contents
Advertisement
Wiring
§
7
.
W
§
7
.
W
§
7
.
1
B
a
§
7
.
1
B
a
！
CAUTION
Connect the battery connectors inside the front cover.
Proceed as follows to connect the battery connectors.
① Remove the front panel of the UPS.
② Remove the screw on the right side of the battery cover, and then remove the battery cover.
③ Remove the insulation tape from the battery connector of the battery pack side.
④ Connect the battery connector.
① Remove by sliding in the direction of
the arrow while firmly pressing the
two locations indicated by ●
⑤ Verify that Forced Bypass is set to "Inverter".
⑥ Attach the battery cover.
⑦ Attach the front panel.
⑥ Insert two claws on the top and
bottom into the slit. Slide the
cover in and secure with the
screw on the right side.
Note
If the battery connector is not connected, when starting
up the UPS, an alarm buzzer sounds.
In this case, stop the UPS, and firmly connect the
battery connector.
21
i
r
i
n
g
i
r
i
n
g
t
t
e
r
y
C
o
n
n
e
c
t
o
t
t
e
r
y
C
o
n
n
e
c
t
o
Wear insulated gloves and take other precautions when connecting the
batteries. Otherwise electric shock can result.
There is a constant voltage (refer to the table) at the battery
terminals. Do not touch them with your hands or short
circuit them. Bodily injury can result.
The battery connector cannot be inserted in the wrong
orientation. If it does not go in, do not try to force it. Doing
so can damage the connector and result in electric shock.
Be careful not to get your hands caught when securing the cover.
④ The connector cannot be inserted in
the wrong orientation. Check the
correct insert orientation, and push
in until you hear a click.
This completes the battery connector connection.
r
C
o
n
n
e
c
t
i
o
n
r
C
o
n
n
e
c
t
i
o
n
③Remove the insulation tape
from the battery connector.
② Loosen this screw, and remove the battery cover
by sliding in the direction of the arrow. This
screw cannot be removed from the battery cover
because it is designed to prevent dropping.
⑦ First catch the claws on the right side,
then push the left side in.
ｓ
Model
E11A102
E11A202
E11A302
⑤ Forced Bypass switch should
be "Inverter" position.
Voltage (max.)
24 V
approx.
48 V
approx.
72 V
approx.
Hide quick links:
Advertisement
Table of Contents
