How To Use Power Management Software - Sanyo Denki SANUPS E11A Series Instruction Manual

§ 1 6 .
§ 1 6 .
H o w t
H o w t
What is Power Management Software "SANUPS SOFTWARE STANDALONE" (supplied CD-ROM)?
This software is used for power supply control or management from the computer by communicating the
UPS to a computer (personal computer or workstation).
Install power management software on your computer.
For more information, refer to the
software.
The following is the minimum system configuration required for the setup and operation of the
SANUPS SOFTWARE STANDALONE.
Computer: AT compatible
CPU: PentiumⅢ ® 500MHz (or greater)
Memory: Minimum of 32 MB (64 MB or more recommended)
Available disk space: Minimum of 95MB
Display: Minimum 640 x 480 pixel resolution
Supported OS: Windows
Windows
Windows
(*1) Service Pack 6 or above. (*2) Standard Edition or Enterprise Edition. (*3) Standard or Enterprise
① Check that "Interface" in the user setting is set to "Workstation". The factory default setting is
"Workstation". See §3.5 "Setting PC Interface" in the
② Connect the "PC/IF" connector of UPS to the computer using the supplied Network cable.
③ Check that network cable connection is not loose.
Connect PC/WS
the "RS-232C" connector of the computer.
Note
CARD I/F connector and PC I/F connecter can not be used simultaneously.
④ Insert the SANUPS SOFTWARE STANDALONE CD-ROM into the CD-ROM drive to install this
program.
The installation program starts automatically. Proceed as instructed on the screen.
⑤ After completing the software installation, reboot the computer.
⑥ Launch the SANUPS SOFTWARE STANDALONE from the Windows Start menu to set up.
This completes preparation to use SANUPS SOFTWARE STANDALONE.
For more usage information, refer to the
management software.
o U s e P o w e r
o U s e P o w e r
Install Guide and User Guide
NT 4.0 (*1),Windows 2000, Windows
® ®
Vista(x86, x64), Windows
® ®
8(x86,x64),Windows Server 2012(x64)
® ®
Connect UPS
to the "PC I/F" connector of the UPS.
side of the cable to
Install Guide and User Guide
M a n a g e m e
M a n a g e m e
in the CD-ROM of the power management
XP(x86, x64) , Windows
®
Server 2008(x86, x64) (*3), Windows
User Settings Guide
side of the cable
If the installation program does not start
automatically, double-click Setup.exe on the
CD-ROM to start installation manually.
in the CD-ROM of the power
Power Management Software
n t S o f t w a r e
n t S o f t w a r e
Server 2003(x86, x64) (*2) ,
®
7(x86, x64) ,
®
for how to set.
Tip
42