Before Use - Sanyo Denki SANUPS E11A102U-J Instruction Manual

Before Use

§ 1 . B e
§ 1 . B e
The procedures to use the UPS are shown in the following. Be sure to proceed as follows to use the UPS safely
and properly.
When not using the power
management software
When the default value does
not need to be changed
1
f o r e U s e
f o r e U s e
Check the safety precautions
Check the usage precautions
Check the contents of the package ⇒ page 8
Install the UPS
Wire the UPS
Check the default value of the user setting. ⇒ pages 26,35 to 37
Charge the UPS
Perform the power outage simulation test
Connect the load devices
Start up the UPS
Turn the load device power on
Check the UPS daily by user
Contact your supplier for maintenance
Maintenance by technically qualified personnel. ⇒ pages 32 to 43
⇒ pages 2 to 5
⇒ pages 6 to 7
⇒ pages 16 to 20
⇒ pages 21 to 24
Install the Power management software on the computer, and
connect this to the UPS with the network cable. ⇒ pages 47 to 48
Change the user setting ⇒
⇒ page 27
⇒ pages 28 to 29
⇒ page 30
⇒ page 31
⇒ page 32
⇒ page 39
UPS is malfunctioning, battery needs to be replaced, etc.
⇒ page 38
When using the power
management software
When the default settings do not match
with your environment or requirements
User settings Guide