Table of Contents
Advertisement
Optional Equipment
§
1
8
.
1
R
§
1
8
.
1
R
This is a switch for turning the UPS ON and OFF from a remote location, and for executing one-touch
shutdown of connected computers.
What is one-touch shutdown?
This is a function for sending a command requesting computer shutdown from the UPS to the power
management software.
Equipment you will need
Remote switch (1)
To control 1 UPS remotely
① Check that MAIN MCCB on the back panel of the UPS
is set to "OFF", and that the input power plug is not
connected to the utility power outlet.
② Connect the remote switch to one of the REMOTE connectors.
③ Connect the UPS input power plug to the utility power outlet, and set MAIN MCCB on the back panel
to "ON".
④ Set the Interface item in the user setting menu.
The following two functions are available, depending on the Interface setting. Select the setting for the
function you want to use. See §3.5 "Setting PC Interface" in the
setting procedure.
1．To perform UPS remote ON/OFF
2．To perform UPS remote ON and one-touch system shutdown
Note about operating the remote switch
Always hold the remote switch ON/OFF switch down for at least 2 seconds.
To control multiple UPS units remotely
You can connect up to 5 UPS units with linked operation cables and control them remotely from a remote
switch. This is called linked operation. For details, see §18.2 "Linked Operation Cable".
53
e
m
o
t
e
S
w
i
t
c
h
e
m
o
t
e
S
w
i
t
c
h
Set the Interface to Standalone.
Set the Interface to Workstation
！
CAUTION
Both REMOTE connectors
have the same function.
User Settings Guide
.
Before wiring, set MAIN MCCB
the back panel of the UPS to
"OFF", disconnect the input power
plug from the utility power outlet,
and make sure the UPS is
completely stopped. Failure to do
so can result in electric shock.
for details on the
on
Hide quick links:
Advertisement
Table of Contents
