Before Use - Sanyo Denki SANUPS E11A Series Instruction Manual

Before Use

§ 1 . B e
§ 1 . B e
The procedures to use the UPS are shown in the following. Be sure to proceed as follows to use the UPS safely
and properly.
When not using the power
management software
When the default value does
not need to be changed
1
f o r e U s e
f o r e U s e
Check the safety precautions
Check the usage precautions
Check the contents of the package ⇒ page 8
Install the UPS
Wire the UPS
Check the default value of the user setting. ⇒ pages 22,31 and 32
Charge the UPS
Perform the power outage simulation test
Connect the load devices
Start up the UPS
Turn the load device power on
Check the UPS daily by user
Contact your supplier for maintenance
Maintenance by technically qualified personnel. ⇒ pages 37 to 38
⇒ pages 2 to 5
⇒ pages 6 to 7
⇒ pages 13 to 17
⇒ pages 18 to 20
Install the Power management software on the computer, and
connect this to the UPS with the network cable. ⇒ pages 42 to 43
Change the user setting ⇒
⇒ page 23
⇒ pages 24 to 25
⇒ page 26
⇒ page 27
⇒ page 28
⇒ page 34
⇒ page 33
When using the power
management software
When the default settings do not match
with your environment or requirements
User settings Guide