Auxiliary/Shutdown/Trigger Harness, 24-Pin Connector - Directed 5906 Installation Manual

Orange: (-) GWA (GROUND WHEN ARMED OUTPUT)
This wire supplies a (-) 500mA ground output as long as the system is armed and while the remote start is
active. This output ceases as soon as the system is disarmed or remote start disengages. The GWA can be
hooked up to a voice module or any accessory which requires a ground when armed.
Note: The Ground When Armed during remote start feature can be programmed OFF (see Anti-grind Output
in Feature Menus for more detail).

Auxiliary/Shutdown/Trigger Harness, 24-pin connector

Important: Never connect the 200mA low current outputs directly to a motor or high current device
WITHOUT a relay.
Pink/White: (-) IGNITION 2/FLEX OUTPUT
This (-) 200mA output wire works in conjunction with the (+) Pink/White wire in the heavy gauge harness.
It comes factory set as Ignition 2 and can be programmed for an Accessory or Starter output. It is typically
used to activate a relay for an additional (+) Ignition, Accessory or Starter wire in the vehicle (see Flex Relay
Function in Feature Menus for more detail).
Note: Programming this wire also affects the timing of the heavy gauge (+) Pink/White wire and vice-versa.
Blue/White: (-) 2ND STATUS/REAR DEFOGGER OUTPUT
This (-) 200mA output is default for status output and will activate as soon as the remote start process begins
and will stay active while the remote start is on, it is typically used to activate a module or any accessory
which requires a ground during the remote start sequence. This wire can also be programmed to activate a
defogger circuit in the vehicle (see Status 2 Output in Feature Menus for more detail).
Red/White: (-) AUX/TRUNK RELEASE OUTPUT
This (-) 200mA output is often used to operate a trunk/hatch release or other relay-driven functions. When the
system receives the command controlling trunk release (for longer than 1.5 seconds) the Red/White wire will
supply an output as long as the transmission continues. This output can also be programmed as a 2nd Unlock
output when driver's priority unlock is desired (see AUX/Trunk Output Type in Feature Menus for more detail).
Black/Yellow: (-) DOME LIGHT OUTPUT
This (-) 200mA output is used to drive the dome light circuit in the vehicle. This output activates when
disarming/unlocking the system and when turning the ignition OFF in the vehicle (ignition controlled Dome
Light is programmable ON/OFF). (see Ign-controlled Dome Light in Feature Menus for more detail).
Dark Blue: (-) STATUS OUTPUT
This (-) 200mA output will activate as soon as the remote start process begins and will stay active while the
remote start is ON, it is typically used to activate an interface module or any accessory which requires a
ground during the remote start sequence.
White/Black: (-) AUXILIARY 3 OUTPUT
This (-) 200mA output is used for controlling any Auxiliary function such as fuel door release or a window
module. This output can be programmed for different applications. (see the AUX 3 options in Feature Menus
for more detail).
White/Violet: (-) AUXILIARY 1 OUTPUT
This (-) 200mA output is used for controlling any Auxiliary function such as fuel door release or a window
module. This output can be programmed for different applications. (see the AUX 1 options in Feature Menus
for more detail).
9
© 2016 Directed. All rights reserved.