Directed 5906 Installation Manual page 26

HD Remote Control:
1. With the HD remote screen blank, press and hold the menu wheel (located on the side) for 3 seconds
until the Settings
2. Toggle the menu wheel until the Adjustments screen appears.
3. Press in on the menu wheel to enter the Adjustments menu.
4. In the Adjustments menu, toggle the menu wheel to highlight the Remote Pair feature and press
in the menu wheel to access Pair . The remote is now ready to pair with the system.
Vehicle Setup for Pairing:
Open at least 1 vehicle door.
•
• Turn ON the vehicles ignition to the RUN position.
Within 5 seconds press and release the Control Center button on the Control Center one time then
•
press it once more and hold it.
• The Control Center LED begins flashing in a single flash pattern and the siren will chirp once to confirm
the system is in pairing mode.
Now release the Control Center Button.
•
5. With both the remote and system in pairing mode, press and hold the
siren chirps to indicate the system has learned the remote ID and is sending its ID to the 2-way remote.
Successful or Failed pair: The HD remote control will indicate a Successful or Failed pairing
6.
and returns to the Adjustments menu. If pairing fails, the remote will go back to the Remote Pair
screen, press the
7. Once the pairing is completed turn OFF the ignition in the vehicle, the siren will sound to confirm
exiting. Now test the remote for functionality.
8. When both the system and remote have exited the Pairing mode, you may now test for functionality.
To exit Pairing Mode on the remote:
Wait 30 seconds without pressing a button on the remote.
•
• Press and release the
To exit Pairing Mode on the system:
• Turn OFF the ignition.
Close the open door.
•
• Wait 60 seconds for the system to automatically exit.
• The siren will sound to confirm exiting.
LCD Remote Control:
1. Press and hold the
displayed on the screen. Release the
2. Press and release the
3. Press and hold the
4. Now release the Control Center Button. The remote is now ready to pair with the system.
Vehicle Setup for Pairing:
Open at least 1 vehicle door.
•
Turn ON the vehicles ignition to the RUN position.
•
• Within 5 seconds press and release the Control Center button on the Control Center one time then
press it once more and hold it.
• The Control Center LED begins flashing in a single flash pattern and the siren will chirp once to confirm
the system is in pairing mode.
Now release the Control Center Button.
•
26
screen appears.
button on the remote again to attempt another pairing.
button on the remote.
button on the remote for 8 seconds, the remote beeps once, Main Menu is
button.
button or the
button until the remote beeps 3 times then release the
button until Remote Pair is displayed on the screen.
button on the remote. The
button.
© 2016 Directed. All rights reserved.