Installation Type 1A (With Chthd1 T-Harness R7) - Directed XPRESSKIT DBALL Installation Manual

Platform: DBALL/DBALL2
Firmware: CHRYSLER

Installation Type 1a (with CHTHD1 T-Harness R7)

See page 6 for
wiring information
This is the only connection required for parking
Parking light output for the Dodge Journey, and the
DBALL MUX connection is not required.
Lights
OR
Pink
12-pin Connector
Ignition
Barrel
(vehicle side)
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
[1]
Connection only required for Dodge Journey.
[2]
Wires not listed in this diagram are not required for the installation.
All adapters are displayed from the wire side (unless specified otherwise).
Connect for Dodge
[2]
Journey only.
(AC) Tach Output: Violet/White: 5
[1]
(MUX) Parking Lights: Violet/Green: 8
(MUX) Parking Lights: Violet/Brown: 9
RAP Off: Yellow/Black: 10
(-) Driver door trigger
Violet wire in
driver kick panel
CHTHD1 R7
(optional)
(harness side)
(+) Parking Light Output
(AC) Tach Input
[1]
RF
DBALL/
Prog. Button
DBALL2
LED
12-pin Connector
(harness side)
(-) Ground (-) Ground
(+) 12V (+) 12V
(-) Hood Switch (-) Hood Switch
(+) Ignition Input/Output
Remote Start Safety
Override Switch is inactive
(used for RSR only)
Do NOT
connect
(+)12V
RX
(-) Ground
TX
P#: XKD2D65
12-pin Connector
(Vehicle side)
© 2015 Directed. All rights reserved.
Rev.: 20150128
Page 3
D2D
only