Programming System Features - Directed 5906 Installation Manual

Parking Light Flashes:
5 flashes
6 flashes
7 flashes
8 flashes

Programming System Features

The System Features Learn Routine dictates how the unit operates. It is possible to access and change most of
the feature settings using the Control Center button.
1. Open a door.
2. Turn the ignition on, then OFF.
3. Select a Menu. Press and hold the Control Center button. The number of siren chirps indicates the
Menu number. 1 LED flash and honk indicates Menu 1, 2 LED flashes and honks - Menu 2 and 3 LED
flashes and honks for Menu 3.
4. When the desired Menu chirps are heard, release the Control Center button.
5. Select a Feature. Press and release the Control Center button the number of times corresponding to
the feature you wish to change. Then press and hold one more time to select the features. Do NOT
release the Control Center button.
6. Program the Feature. While holding the Control Center button, you can program the feature using the
remote control.
7. The Control Center LED will flash and the siren will chirp the number of times equal to the option.
For features with only two options;
For features with more than two options;
descending order.
Note: Pressing
button resets the feature to the factory default.
Once a feature is programmed:
• Other features can be programmed within the same menu.
• Another Menu can be selected.
• The Learn Routine can be exited if programming is complete.
To access another feature in the same menu:
1. Press and release the Control Center button the number of times necessary to advance from the
feature just programmed to the next one desired to program.
2. Then press the Control Center button once more and hold it.
To select another menu:
1. Press and hold the Control Center button.
2. After 3 seconds, the unit advances to the next Menu, the siren chirps, indicating which Menu has been
accessed.
The Learn Routine exits if any of the following occurs:
• The open door is closed.
• The ignition is turned ON.
• There is no activity for 30 seconds.
• The Control Center button is pressed too many times.
15
Brake input is active
Hood pin input is active
Manual transmission mode is enabled and not initialized
Neutral safety wire has no ground or the neutral safety switch is OFF
= option 1, while
selects the options in ascending order, while
= option 2.
selects them in
© 2016 Directed. All rights reserved.