Learning Hardwired Or Data Tach (Not Needed With Virtual Tach); Remote Start Shutdown/Startup Diagnostics - Directed 5906 Installation Manual

Learning Hardwired or Data Tach (not needed with Virtual
Tach)
To learn the tach signal:
1. Start the vehicle with the key. Within 5 seconds, press and hold the Control Center button.
2. After 3 seconds the status LED on the Control Center lights solid when the tach signal is learned.
3. Release the Control Center button.
Note: When the tachometer is programmed, the main unit automatically enters the Tachometer Engine
Checking Mode.

Remote Start Shutdown/Startup Diagnostics

Shutdown diagnostics: If the remote start activates but fails to stay running, the remote start module has
the ability to inform you of what may have caused the remote start failure. Before performing shutdown
diagnostics it is important that you let the remote start shut OFF on its own i.e., let it attempt to start 3 times
then shut down, if this is not done the unit will report the shutdown last used to shut OFF the remote start.
Note: Shutdown diagnostics does not report if the vehicles factory immobilizer is causing the problem.
To perform shutdown diagnostics:
1. With the ignition OFF, press and hold the Control Center button.
2. Turn the ignition ON and then back OFF while holding the Control Center button.
3. Release the Control Center button.
4. Press and release the Control Center button. The status LED flashes to report the last shutdown for
one minute or until the ignition is turned ON, as shown in the following table:
Status LED Flashes
1 flash
2 flashes
3 flashes
4 flashes
5 flashes
6 flashes
7 flashes
8 flashes
9 flashes
10 flashes
11 flashes
* Timer Mode error: Ignition is ON or shutdown input is active when activating Timer Mode.
Turbo Mode error: Turbo mode is programmed OFF, engine is not ON or shutdown input is active.
Manual Mode error: MTS mode not enabled.
** Alarm was triggered during remote start sequence.
Startup Diagnostics: If the vehicle fails to activate the remote start, the remote start module will notify you
via 2-way remote control and the remote start module will flash the parking lights on the vehicle to notify you
of what caused the no-start situation.
14
Shutdown Mode
Runtime expired
Over-rev shutdown
Low or no RPM
Transmitter shutdown (or optional push button)
(+) Brake shutdown
(-) Hood shutdown
Timer Mode/Turbo Mode/Manual Mode error*
Neutral safety shutdown
Low battery (voltage mode)
Alarm triggered**
Wait-to-start input timed out
© 2016 Directed. All rights reserved.