Directed 5906 Installation Manual page 8

White/Brown: PARKING LIGHTS FLASH ISOLATION WIRE (#87a of onboard relay)
This wire is a parking lights flash input from the vehicle light switch which connects to #87a of the onboard
lights flash relay. It is used for vehicles requiring light switch isolation during parking lights flash output. For
vehicles with multiplex light circuits which require a resistor, the onboard lights flash fuse can be replaced
with the specified resistor value (pay attention to appropriate circuit polarity). See the following diagram for
wiring information.
Light Switch
Multiplex wire
in vehicle
White/Brown
To Control
Module in
vehicle
White: (+) or (-) PARKING LIGHTS OUTPUT
This wire should be connected to the parking lights wire in the vehicle. It activates when the system is armed/
disarmed, remote started, when the alarm is triggered, and is also used for certain diagnostics. It can be set
for a (-) or (+) output. See the following diagram for setting the lights flash polarity.
Note: Any parking lights circuit which draws 10 amperes or more must use P/N 8617 (or a standard
automotive SPDT relay) to drive the circuit in the vehicle.
8
White
LIGHT FLASH POLARITY
JUMPER Detail
Note: Replace fuse with speci ed resistor value
if connecting to multiplex light circuit
(pay special attention to polarity selection)
LIGHT FLASH POLARITY
JUMPER Detail
Place the fuse in the correct
position for the desired polarity
© 2016 Directed. All rights reserved.