Directed 5906 Installation Manual page 22

6. Turbo Mode
1. No Turbo Mode: Turbo Mode is not available.
2. On – 1/3/5/10 minutes: Turbo Mode is available and, when activated, the engine will run for the
duration set per the selected option.
7. Timer Mode Runtime
• 12/3/6/9 minutes: sets the runtime when the engine is started by the Timer Mode and SmartStart
features.
8. Ignition 2/Flex Relay Function
1. Ignition 2: the relay will emulate the Ignition 1 output during remote start.
2. Accessory 2: the relay will emulate the Accessory 1 output during remote start.
3. Starter 2: the relay will emulate the Starter output during remote start.
Note: Changing this feature not only affects the (+) Ign. 2/Flex Relay, Pink/White heavy gauge wire, it
will also affect the (-) Ign. 2 Pink/White wire in the 24-pin harness.
9. Diesel Start Delay
1. WTS (Wait-To-Start) input: (-) input on the Gray/Black WTS wire (24 pin harness) will delay the
starter output until the ground ceases.
2. Timed 15/30/45 seconds: delays the starter output per the selected option, the WTS wire does not
function.
10. Accessory During Diesel Start Delay
1. ON: the Accessory outputs (Orange wire 10-pin harness (high current) and Orange wire 24-pin
harness (low current)) will be ON during diesel start delay.
2. OFF: the Accessory outputs (Orange wire 10-pin harness (high current) and Orange wire 24-pin
harness (low current)) will be OFF during diesel start delay.
11. Status 2 Output (Blue/White wire on 24-pin harness)
1. Status: the output will activate before the ignition outputs turn on, and de-activate after they turn OFF
during remote start.
2. Latch rear defogger: the output activates 10 seconds after start if the interior temperature is below
55˚F. It turns OFF after 10 minutes or upon remote start OFF.
3. Pulse rear defogger: the output activates (for 800 ms) 10 seconds after start if the interior
temperature is below 55˚F.
Note: If the rear defogger feature is programmed ON, the customer can still enable/disable the output
with the remote.
12. Parking Light Output
1. Constant: the lights will turn ON solid during remote start.
2. Pulsed: the lights will pulse ON/OFF during remote start.
3. OFF: the lights will be OFF during remote start.
Note: If the parking lights have been programmed to be OFF during the remote start runtime, the
parking lights will still flash upon activation of the remote start and during startup diagnostics.
13. Anti-grind Output
1. On: the high current starter relay will be activated during remote start as anti-grind protection.
2. OFF: the high current starter relay will not be activated during remote start, no anti-grind protection
is available.
Note: The Anti-grind feature works in conjunction with the Orange GWA wire in the main 6-pin
connector.
22
© 2016 Directed. All rights reserved.