Directed 5906 Installation Manual page 19

1. One-time Bypass
1. OFF: One-Time Bypass is not available.
2. On: the One-Time Bypass feature will defeat Passive Arming once and, if Armed by remote control,
will defeat Comfort Closure and AUX outputs linked to Arming.
2. NPC (Nuisance Prevention Circuitry)
1. ON: sensors that trigger excessively will be defeated until they have been stable for more than one
hour.
2. OFF: sensors will not be defeated if triggered excessively.
3. Override Pulse Count
• 1-5: sets the number of presses (1-5) on the Control Center button required to override the alarm
system if a remote is damaged or not available if a remote is damaged or not available.
4. Door Open Error Chirp
1. ON: if the door trigger is active when arming, the siren will emit a chirp and a message will be sent
to the 2-way remote control as an alert.
2. OFF: an active door trigger when arming will not create an alert output.
5. Ign-controlled Dome light
1. ON: the dome light output will activate when the ignition is turned OFF.
2. OFF: the dome light output will not activate when the ignition is turned OFF.
6. OEM Alarm Disarm with AUX/Trunk (Green/Black wire, 24-pin harness)
1. ON: the OEM Alarm Disarm wire will pulse as programmed when the AUX/Trunk output is
activated.
2. OFF: the OEM Alarm Disarm wire will not pulse when the AUX/Trunk output is activated.
7. OEM Alarm Disarm Output (Green/Black wire, 24-pin harness)
1. With Unlock: the OEM Alarm Disarm wire will pulse as programmed at the same time as the unlock
(Blue) wire.
2. Before Unlock: the OEM Alarm Disarm wire will pulse as programmed before the unlock wire.
3. Remote start only: the OEM Alarm Disarm wire will pulse as programmed during remote start only.
8. OEM Alarm Disarm Pulses (Green/Black wire, 24-pin harness)
1. The OEM Alarm Disarm wire will pulse once per operation.
2. The OEM Alarm Disarm wire will pulse twice per operation.
9. AUX 1 Output Type (White/Violet wire, 24-pin harness)
1. Validity: when the AUX command is received the wire will turn ON and remain ON until the
command ceases.
2. Latch: when the AUX command is received the output will turn ON and remain ON until the
command is received again.
3. Latch/Reset/Ignition: when the AUX command is received the wire will turn ON and remain ON
until the command is received again or the ignition is turned ON & OFF.
4. Timed: when the AUX command is received the output will turn ON for the programmed time
duration (default 30sec.).
5. OFF: the output will not activate for a remote control command, use this option when the AUX
command controls an external device such as a garage door module.
6. 2nd Unlock: the output will operate as 2nd Unlock and will not activate for remote control
commands.
19
© 2016 Directed. All rights reserved.