Door Lock, 3-Pin Connector - Directed 5906 Installation Manual

Pink/Black: FLEX RELAY INPUT
This wire is #87a of the onboard 2nd Ignition/Flex Relay. This wire prevents having to use additional relays
in vehicles which require ignition switch isolation like shown in Tech Tip #1077.
Note: This wire will only be used in special situations when the ignition switch needs to be isolated during
the remote start sequence and is not used in most installations.
Pink/White: IGNITION 2/FLEX RELAY OUTPUT
This wire typically is connected to the Ignition 2 circuit in the vehicle. If the vehicle does not have a 2nd
Ignition but does have a 2nd accessory or a 2nd starter, it can be programmed to be used to power additional
Accessory or Starter cicuits in the vehicle (see Flex Relay Function in Feature Menus for more detail).
Red: (+) 12V INPUT
This wire connects to a (+) 12V source and is the power feed for the onboard Ignition relay.
Green: STARTER INPUT
This wire is #87a of the onboard starter disable relay. After cutting the Starter wire in the vehicle, this wire will
connect to the ignition switch-side of the cut starter wire in the vehicle. This wire is not a mandatory connection
and will not prevent the remote start from activating.
Violet: STARTER OUTPUT
This wire is #30 of the onboard starter disable relay and connects to the car side of the cut Starter wire in
the vehicle. If the onboard starter disable relay is not used, connect this wire to the Starter wire in the vehicle.
Note: Some newer vehicles may not have a Starter wire at the ignition switch, therefore it may not need to
be connected to the vehicle.
Orange: ACCESSORY OUTPUT
This wire connects to the Accessory circuit in the vehicle and operates as the Accessory wire at the ignition
switch. When the remote start is activated this wire will activate, deactivate during the cranking cycle of the
remote start, and will re-activate after the cranking cycle is done.
Red/White: (+) 12V INPUT
This wire connects to a (+) 12V source and is the power feed for the onboard Ignition 2/Flex Relay.
Pink: IGNITION INPUT/OUTPUT
This wire connects to the main Ignition circuit in the vehicle. It will supply voltage to the Ignition circuit in the
vehicle during the remote start sequence and is also the Ignition input to the unit while the remote start is not
activated.

Door Lock, 3-pin connector

Blue: (-) UNLOCK OUTPUT
This (-) 500mA output connects to the (-) unlock wire in the vehicle or to a relay for vehicle specific applications.
This wire will output a pulse when disarming the system. It can be programmed to unlock the vehicle when the
ignition is turned OFF, for a double pulse output and for output duration (see Ign-controlled Locks, Door Lock
Pulses or Door Lock Duration in Feature Menus for more detail).
Empty Pin: N/A
Although this connector is not populated with a wire in this position, the pin on the unit supplies a low current
(+) 12V output and is utilized when using a P/N 451 Door Lock Relay Module.
12
© 2016 Directed. All rights reserved.