Directed DS4+ Installation Manual
  1. Manuals
  2. Brands
  3. Directed Manuals
  4. Remote Starter
  5. DS4+
  6. Installation manual
Directed DS4+ Installation Manual

Directed DS4+ Installation Manual

Hide thumbs Also See for DS4+:
Table of Contents

Advertisement

Quick Links

Download this manual
INSTALLATION GUIDE
TL4
Designed by Installers for Installers
© 2017 Directed, Vista CA
This product is intended for installation by a professional installer only! Attempts to install this
product by a person other than a trained professional may result in severe damage to a vehicle's
electrical system and components.
2017-09-25
DS4+

Advertisement

Table of Contents
loading

Related Manuals for Directed DS4+

Summary of Contents for Directed DS4+

  • Page 1 INSTALLATION GUIDE Designed by Installers for Installers © 2017 Directed, Vista CA This product is intended for installation by a professional installer only! Attempts to install this product by a person other than a trained professional may result in severe damage to a vehicle’s electrical system and components.

  • Page 2: Table Of Contents

    Contents Warning! Safety first ........................3 Introduction ............................ 4 Pre-installation and application warnings ..................4 Vehicle application guide ......................5 Wiring connections ......................... 6 Main harness (H1), 12-pin black connector .................. 6 Relay harness (H2), 10-pin white connector .................. 6 Data harness (H3), 8-pin white connector ..................

  • Page 3: Warning! Safety First

    The following safety warnings must be observed at all times: • Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. • When properly installed, this system can start the vehicle via a command signal from the remote control. Therefore, never operate the system in an area that does not have adequate ventilation.

  • Page 4: Introduction

    Autolights connection ONLY required in vehicles with autolights. Additional parts required (maximum required): Resistor 100Ω Fuse 7.5A Diode 6A 0 x 1A Diodes 0 x Resistor 0 x Fuse 0 x Relay DS4+ TL4 © 2017-09-25 Directed. All rights reserved.

  • Page 5: Vehicle Application Guide

    • • • • • Legend: PK: Transponder & Immobilizer Override FOB: Sync CAN Interface w/ FOB Remote RS: Remote Start & Engine Controls SS: Integrated Security & Monitoring ST: Function/Feature Status DS4+ TL4 © 2017-09-25 Directed. All rights reserved.

  • Page 6: Wiring Connections

    (MUX) Analog Input/Output H3/7 Orange/Black IMO Data H3/8 Yellow/Black IMI Data If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed. DS4+ TL4 © 2017-09-25 Directed. All rights reserved.

  • Page 7: Analog Input/Output Harness (H4), 22-Pin White Connector

    If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed. Note that they are low current and a relay may be necessary. DS4+ TL4 © 2017-09-25 Directed. All rights reserved.

  • Page 8: Installation (Wiring Diagrams, Fuse Selection & Vehicle Wiring Reference Charts)

    Lt. Blue, pin 17 It is important to check that the Power ECU. fuses are positioned correctly. (White conn. behind glove box) Ignition 2: Lt. Blue, pin 34 Ignition 1: Yellow, pin 35 DS4+ TL4 © 2017-09-25 Directed. All rights reserved.
  • Page 9 White Lock Lt. Green Power Window Master Switch in driver door. White Unlock Pink Power Window Master Switch in driver door. White Trunk Release Blue Body ECU (RH) behind glove box. White DS4+ TL4 © 2017-09-25 Directed. All rights reserved.

  • Page 10: Type 2

    (+) Ignition Input/Ouput: Pink: 10 (White conn. behind clock assembly) Refer to the next page for wire and connector details. It is important to check that the fuses are positioned correctly. DS4+ TL4 © 2017-09-25 Directed. All rights reserved.
  • Page 11 (+) 12V Input: Red/White: 9 DS4+ (+) Ignition Input/Ouput: Pink: 10 (from Engine Room Main Wire) (from Instrument (from Engine Room Panel Wire) Main Wire) (from Instrument Panel Wire) Fuse Box (Rear) DS4+ TL4 © 2017-09-25 Directed. All rights reserved.
  • Page 12 ECM next to underhood fuse box. Black Green Data ECM next to underhood fuse box. Black Lock Blue Driver Kick Panel. Blue Unlock Green Driver Kick Panel. Blue Trunk Release Gray Driver Kick Panel. White DS4+ TL4 © 2017-09-25 Directed. All rights reserved.

  • Page 13: Type 3

    (+) 12V: Black, pin 1 Starter 1: Fuse Box Black, pin 17 (White conn. under driver dash) (+) Ign. 2: Lt. Green, pin 34 (+) Ignition 1: Yellow, pin 35 DS4+ TL4 © 2017-09-25 Directed. All rights reserved.
  • Page 14 White Starter 2 Lt. Blue Power Source Control ECU behind glove box. White Lock Black Driver Kick Panel. White Unlock Gray Driver Kick Panel. White Trunk Release Blue Trunk Release Switch. White DS4+ TL4 © 2017-09-25 Directed. All rights reserved.

  • Page 15: Type 4

    It is important to check that the pin 1 fuses are positioned correctly. (+) Ignition 2: Passenger Fuse Box (+) Ignition 1: Pink, pin 34 (White 1-pin conn.) Lt. Green, pin 35 DS4+ TL4 © 2017-09-25 Directed. All rights reserved.
  • Page 16 Driver Kick Panel. White Lock Blue Power Window Master Switch in driver door. White Unlock White Power Window Master Switch in driver door. White Trunk Release Pink 4 or 6 Trunk Release Switch. Black DS4+ TL4 © 2017-09-25 Directed. All rights reserved.
  • Page 17 Driver Kick Panel. White Lock Blue Power Window Master Switch in driver door. White Unlock White Power Window Master Switch in driver door. White Trunk Release Pink 4 or 6 Trunk Release Switch. Black DS4+ TL4 © 2017-09-25 Directed. All rights reserved.
  • Page 18 Driver Kick Panel. White Lock Blue Power Window Master Switch in driver door. White Unlock White Power Window Master Switch in driver door. White Trunk Release Pink 4 or 6 Trunk Release Switch. Black DS4+ TL4 © 2017-09-25 Directed. All rights reserved.

  • Page 19: Type 5

    (+) Ignition 1: Black/Red, pin 6 DS4+ to open (+) Ignition 1 Output: Pink: 10 (+)12V: Blue/Black, pin 7 It is important to check that the (+) Starter 1: Green/Black, pin 8 fuses are positioned correctly. DS4+ TL4 © 2017-09-25 Directed. All rights reserved.
  • Page 20 Headlight Switch. Black Security Light Violet/White A/C Amplifier behind radio. White Blue/Orange Data ECM behind glove box, second connector from bottom. White Blue/Yellow Data ECM behind glove box, second connector from bottom. White DS4+ TL4 © 2017-09-25 Directed. All rights reserved.

  • Page 21: Type 6

    (+) Ignition 1 Output: Pink: 10 to open (+) Ignition 1: Yellow, pin 35 (+) 12V: It is important to check that the Fuse Box Black, pin 1 fuses are positioned correctly. (White conn. under driver dash) DS4+ TL4 © 2017-09-25 Directed. All rights reserved.
  • Page 22 White Starter 2 Lt. Blue Power Source Control ECU behind glove box. White Lock Black Driver Kick Panel. White Unlock Gray Driver Kick Panel. White Trunk Release Blue Trunk Release Switch. White DS4+ TL4 © 2017-09-25 Directed. All rights reserved.

  • Page 23: Configuring The System

    DO NOT connect the SmartStart 2-pin power harness when using the DS4+. Power and ground will be provided by the D2D connector on main module. Refer to the SmartStart documentation for further details. DS4+ TL4 © 2017-09-25 Directed. All rights reserved.

  • Page 24: D2D Port Configuration

    By default, the tachometer is preprogrammed for the vehicle. For instructions on how to Initialize tachometer program tach, see page 28. * Your aftermarket remote may differ from the model shown in the illustrations. You have successfully completed the module programming sequence. DS4+ TL4 © 2017-09-25 Directed. All rights reserved.

  • Page 25: Led Diagnostics And Troubleshooting

    External module synchronization Description Troubleshooting OBDII feature not supported. The diagnostic data bus was not detected, therefore the SmartStart features will be limited. (Flashes red, red, then orange) x 10 DS4+ TL4 © 2017-09-25 Directed. All rights reserved.
  • Page 26 The vehicle was detected as moving, which prevents the system from shutting it down. Flashes red x 4 Analog error codes Description Troubleshooting DEI feature error. A feature config file mismatch was detected. Please contact Technical Support. Flashes red, green & orange DS4+ TL4 © 2017-09-25 Directed. All rights reserved.

  • Page 27: Soft Reset

    After 3 seconds the LED turns ON solid orange. Keep holding the programming button until & & the LED flashes red, then orange slowly. Solid Hold Flashes Release the programming button. The LED turns ON solid red. & Release Solid DS4+ TL4 © 2017-09-25 Directed. All rights reserved.

  • Page 28: Learning The Tach (Not Needed With Virtual Tach)

    Important! After successfully learning Virtual Tach, a small minority of vehicle starters may over crank or under crank during remote start. Use the VirtualTach Fine tune feature using the DirectLink application for mobile devices to adjust the starter output time in 50mS increments to compensate for such an occurrence. DS4+ TL4 © 2017-09-25 Directed. All rights reserved.

  • Page 29: Limited Lifetime Consumer Warranty

    Directed dealer, the unit was professionally installed and serviced by an authorized Directed dealer; the unit will be professionally reinstalled in the vehicle in which it was originally installed by an authorized Directed dealer; and the unit is returned to Directed, shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the following information: consumer’s name, telephone number and address;...

  • Page 30: Quick Reference Guide

    The application enables a “Cloud-Connected Car” like never before, providing doors of your vehicle when leaving it unattended. 2-way interaction with your vehicle. Connectivity is managed through the Directed Cloud Services (DCS) network linking car, app, end user, and the Internet.
  • Page 31 Notes DS4+ TL4 © 2017-09-25 Directed. All rights reserved.

Table of Contents