Table of Contents
Advertisement
Remote Start, White 10-pin heavy gauge connector
1
NC
2
RED/BLACK
3
PINK/BLACK
4
PINK/WHITE
5
RED
6
GREEN
7
VIOLET
8
ORANGE
9
RED/WHITE
10
PINK
Door Lock, 3-pin connector
1
BLUE
2
EMPTY
3
GREEN
D2D Harness, Red 4-pin connector
1
BLUE
2
BLACK
3
GREEN
4
RED
Bitwriter/Directed SmartStart Harness, Black 3-pin connector
1
RED
2
ORANGE
3
BLACK
Wire Descriptions
Main Harness, 6-pin connector
Red: (+) 12V CONSTANT INPUT
This wire supplies power to the unit's micro-controller. Remove the supplied fuse before connecting to the (+)
terminal of the battery or another constant +12V supply. Make sure to replace the fuse when all connections
have been made.
Note: Always use a fuse within 12 inches of the point from which you obtain (+) 12V. Do not use the 15A
fuse in the harness for this purpose. This fuse protects the module only.
Black: (-) CHASSIS GROUND
This wire is the unit's source of ground. DO NOT connect this wire to any factory ground points; they can
cause noise and/or voltage drops which can affect system performance. Ground the unit and any accessories
to the same point in the vehicle (preferably the kick panel). Scrape away any paint and make your own
ground with a screw and a star washer.
Brown: (+) SIREN OUTPUT
This wire is the (+) output for the siren. This wire connects to the (+) input of the siren.
7
No Connection
(+) FUSED 12V ACCESSORY/STARTER INPUT
(+) FLEX RELAY INPUT #87a key side (if required) of FLEX RELAY
(+) IGNITION 2 / FLEX RELAY OUTPUT #30 of FLEX RELAY
(+) FUSED 12V IGNITION 1 INPUT
(+) STARTER INPUT (KEY SIDE OF THE STARTER DISABLE)
(+) STARTER OUTPUT (CAR SIDE OF THE STARTER DISABLE)
(+) ACCESSORY OUTPUT
(+) FUSED 12V IGNITION 2 / FLEX RELAY INPUT 87
(+) IGNITION 1 INPUT/OUTPUT
(-) 500mA UNLOCK OUTPUT
NOT USED
(-) 500mA LOCK OUTPUT
D2D - TX
(-) GROUND
D2d - RX
(+) 12V
(+) 12V
ESP 2 - RX/TX
(+) 12V
© 2016 Directed. All rights reserved.
Hide quick links:
Advertisement
Table of Contents
