Installation (Wiring Diagrams & Vehicle Wiring Reference Charts) With T-Harness Thchd3 - Directed DBALL2 Installation Manual

Platform: DBALL2
Firmware: CHRYSLER7 Remote Start Ready Installation (RSR)
Installation with T-Harness THCHD3
OBDII
Diagnostic 16-pin Connector
(vehicle side)
OBDII
Harness
in driver kick panel
With the exception of the OBDII Diagnostic connector, all connectors are displayed from the wire side.
OR
T-02
6-pin connector (vehicle side)
(-) Driver Door Trigger:
Violet
Vehicle
6
Headlamp Switch
5
(6-pin Connector)
4
3
(MUX) Parking Lights: White/Brown, pin 3
2
1
These T-Harness connectors are
NOT interchangeable. They will fit
ONLY the appropriate vehicles.
6-pin
Connectors
T-01
NOT Used
PTS Switch
Brake Connector
1
2 3 4
Brake:
Dk.Green/Lt. Green,
pin 1
Brake Output: Yellow/Red
(-) RAP Off: Orange/Black
(MUX) Parking Lights Output: Violet/Brown
OBDII
Diagnostic 16-pin Connector
(vehicle side)
Keyless
Ignition
Node
THCHD3 Rev. 1
(Optional T-Harness)
The Remote Start
Safety Override
Switch MUST be in
the ON position.
Remote Start Safety
Override Switch
RF
Prog. button
DBALL2
LED
You can connect to either a XL202
RFTD OR a SmartStart module.
Refer to the SmartStart/XL202
Installation Notes for more information.
© 2016 Directed. All rights reserved.
Rev.: 20160610
Page 4
OBDII