Remote Start Heavy Gauge Harness, 10-Pin Connector - Directed 5906 Installation Manual

Responder hd, lcd, led and 1-way models security and remote start

Hide thumbs

Table Of Contents

Table of Contents

Brown/Black: (-) HORN HONK OUTPUT

This wire supplies a (-) 200mA output which can be used to honk the vehicle's horn. This wire outputs pulses

when the alarm has been triggered. This output can be programmed to operate similar to the siren so it

outputs a single pulse when locking/arming the doors with the remote, and two pulses when unlocking/

disarming with the remote. (see Horn Function in Feature Menus for more detail).

Pink: (-) IGNITION 1 OUTPUT

This (-) 200mA output wire works in conjunction with the Pink wire in the heavy gauge harness. It is typically

used to activate a relay for an additional Ignition wire in the vehicle.

Violet: (+) DOOR TRIGGER INPUT

This input wire is used in vehicles with (+) door trigger and will sound the alarm when any of the vehicle's

doors are opened. This wire (for the Green (-) Door Trigger input) is a required connection when installing the

system in a manual transmission vehicle.

Violet/Black: (-) AUXILIARY 2 OUTPUT

This (-) 200mA output is used for controlling any Auxiliary function such as a fuel door release or a window

module. This output can be programmed for different applications. (see the AUX 2 options in Feature Menus

for more detail).

Brown: (+) BRAKE SHUTDOWN INPUT

This input wire connects to the (+) foot brake wire in the vehicle. When connected the remote start will be

disabled or shutdown anytime the foot brake pedal is depressed.

Violet/Yellow: (-) STARTER OUTPUT

This (-) 200mA output wire works in conjunction with the Violet wire in the heavy gauge harness. It is typically

used to activate a relay for an additional Starter wire in the vehicle.

Gray/Black: (-) DIESEL WTS (WAIT-TO-START) INPUT

This input wire connects to the (-) Wait-To-Start wire in a diesel-engine vehicle and will keep the Starter output

from engaging while this wire is receiving a ground.

Orange: (-) ACCESSORY OUTPUT

This (-) 200mA output wire works in conjunction with the Orange wire in the heavy gauge harness. It is

typically used to activate a relay for an additional Accessory wire in the vehicle.

Green/White: (-) FACTORY ALARM ARM OUTPUT

This 200mA output is used to arm the factory alarm and outputs when the system is armed and 4 seconds

after the remote start deactivates. It typically connects to the Factory Alarm Arm wire in the vehicle.

Note: The Factory Alarm Arm wire will not output a pulse when the remote start deactivates if the heavy

gauge Pink wire has +12V.

Important: Never connect the 200mA low current centeer outputs directly to a motor or high current

device WITHOUT a relay.