Qos - Polycom CX5100 Administrator's Manual

Provisioning Parameters (continued)
Parameter
If 1, a user must log in when the login feature is enabled. If 0, the user does not have to log in.
prov.loginCredPwdFlushed.enabled
If 1, when a user logs in or logs out, the login credential password is reset. If 0, the login credential password is not
reset.
prov.polling.enabled
If 0, the provisioning server is not automatically polled for upgrades. If 1, the provisioning server is polled.
prov.polling.mode
The polling mode.
abs The system polls every day at the time specified by prov.polling.time.
rel The system polls after the number of seconds specified by prov.polling.period.
random The system polls at random between a starting time set in prov.polling.time and an end time set in
prov.polling.timeRandomEnd.
Note that if you set the polling period in prov.polling.period to a time greater than 86400 seconds (one day)
polling occurs on a random day within that polling period (meaning values such as 86401 would be over 2 days) and
only between the start and end times. The day within the period is decided based upon the systems MAC address
and does not change with a reboot whereas the time within the start and end is calculated again with every reboot.
prov.polling.period
The polling period in seconds. The polling period is rounded up to the nearest number of days in absolute and
random mode. In relative mode, the polling period starts once the system boots. In random mode, if this is set to a
time greater than 86400 (one day) polling occurs on a random day based on the system's MAC address.
prov.polling.time
The polling start time. Used in absolute and random modes.
prov.polling.timeRandomEnd
The polling stop time. Only used in random mode.
prov.quickSetup.enabled
If 0, the quick setup feature is disabled. If 1, the quick setup feature is enabled.
1
Change causes system to restart or reboot.
<qos/>
These parameters listed in the next table configure the following Quality of Service (QoS) options:
● The 802.1p/Q user_priority field RTP, call control, and other packets
● The "type of service" field RTP and call control packets
Polycom, Inc.
Permitted Values
0 or 1
0 or 1
abs, rel, random
integer > 3600
hh:mm
hh:mm
0 or 1
Configuration Parameters
Default
1
0
abs
86400
03:00
Null
0
65