Upgrade; Video - Polycom CX5100 Administrator's Manual

<upgrade/>
Use the parameters listed in the next table to specify the URL of a custom download server and the Polycom
UC Software download server for the system to check when searching for software upgrades.
Upgrade Server Parameters
Parameter
upgrade.custom.server.url
The URL of a custom download server.
upgrade.plcm.server.url
The URL of the Polycom software download server.
<video/>
The parameters in the following table include parameters you can use to configure video for the CX5100
system. This parameter also includes:
● <camera/>
● <codecs/>
Video Parameters
Parameter
video.autoFullScreen
If 0, video calls only use the full screen layout if it is explicitly selected by the user. If 1, video calls use the full screen
layout by default, such as when a video call is first created or when an audio call transitions to a video call)
video.autoStartVideoTx
When enabled, video transmission to the far side begins when you start a call. When disabled, video transmission
does not begin until you press the Video > Start Video soft keys. This parameter controls video sent to the far side.
Video from the far side always displays if available, and far side users can control when to send video.
video.callMode.default
When the device uses SIP protocol, this parameter allows users to select the outbound call mode.
video.callRate
The default call rate (in kbps) to use when initially negotiating bandwidth for a video call.
video.dynamicControlMethod
If 1, the first I-Frame request uses the method defined by
subsequent requests alternate between RTCP-FB and SIP INFO.
video.enable
Polycom, Inc.
Permitted Values Default
URL Null
URL
http://downloads.polycom.com/voice/m
illennium_cx_series
Permitted Values
0 or 1
0 or 1
audio or video
128 to 2048
0 or 1
video.forceRtcpVideoCodecControl
0=Disable, 1=Enable
Configuration Parameters
Default
0
1
audio
512
0
1
and
79